We Offer Revolution Of Industrial Engineering
More Information
+1 (561) 757-5620
+1 (561) 757-5620
DESCRIPTION AND RECOMMENDED USES: 100% solids, Dura-Coat Membrane 910 is a high-elongation hybrid urethane elastomer. It is ideal for tank chimes and is fully compatible with metal, concrete, and other substrates. The elastomer provides high strenght and flexibility, while ceramic reinforcement enhances abrasion resistance. Membrane 910 can be easily applied by brush up to 40 mils without sagging.
| Maximum Temperature (Dependent on service) | Wet Service | Dry Service | -30°C | 93°C | -22°F | 200°F |
|---|---|---|---|
| Chemical Resistance | Water | Alkalis | Inorganic Acids | Organic Acids | Organic Solvents | Excellent | Excellent | Excellent | Fair | Poor | |
| Elongation | 200% | ||
| Specific Gravity | 1.4 | ||
| Hardness | 93 Shore A | ||
| Vertical SAG Resistance at 21ºC (70ºF) and 1 mm (40 mils) | No sag | ||
| Coverage for 1kg Kit | 7.5sf @40mils | 0.7m² @1mm | |
| Mix Ratio | 6:1 by weight | Base: Activator | |
| Color | Gray | ||
| Shelf life (unopened containers) | 3 years at 55-95ºF (13-35ºC) | ||
Surface Preparation
Proper surface preparation is vitally important to the long-term performance of Dura-Coat Membrane 910. The surface should be clean and rough. Prepare with mechanical cleaning with a rotation wire brush. Clean with solvents (acetone, xylene, alcohol or MEK) and a cloth. No primer is required, Dura-Coat Membrane 910 is applied directly to metal or concrete.
Mixing
Mix the activator well into the base with the mixing rod scraping down the sides and bottom of the container. Mix by weight 6 part Base with 1 part Activator. Mix thoroughly to produce a uniform, streak-free material. Never put solvents.
Application
Dura-Coat Membrane 910 can be applied by brush.
To avoid sagging on vertical surfaces, the maximum thickness per layer should be up to 1mm (40 mil) per layer.
| 16°C (60°F) | 25°C (77°F) | 32°C (90°F) | |
|---|---|---|---|
| Tack Free | 4 hours | 2 hours | 1 hour |
| Light Load | 12 hours | 6 hours | 3 hours |
| Overcoat End | 16 hours | 10 hours | 5 hours |
| Full Load | 24 hours | 12 hours | 6 hours |
| Full Chemical | 48 hours | 24 hours | 12 hours |
Clean Up
Tools must be immediately cleaned after usage by using industrial alkaline detergent.
Safety
Before using any products, review the appropriate Safety Data Sheet (SDS) or Safety Sheet for your area. Follow standard confined space entry and work procedures, if appropriate.