We Offer Revolution Of Industrial Engineering
More Information
+1 (561) 757-5620
+1 (561) 757-5620
DESCRIPTION AND RECOMMENDED USES: 100% solids, Dura-Coat 610 is a solvent free, ceramic filled coating designed particularly as a protective coating for metallic surface where only a mechanical preparation is available and for damp sufarces as well. Excellent in a wide array of caustics and acids. Dura-Coat 610 can be easily applied by brush or roller up to 25 mils without slump.
| Maximum Temperature (Dependent on service) | Wet Service | Dry Service | 90°C | 150°C | 194°F | 320°F |
|---|---|---|---|
| Chemical Resistance | Water | Alkalis | Inorganic Acids | Organic Acids | Organic Solvents | Excellent | Excellent | Good | Good | Good | |
| Solids by Volume | 100% | ||
| Mixed Density | 1.4 | ||
| Shore D Durometer Hardness | (ASTM D 2240) | 80 | |
| Pot life | 25 MIN / KG at 72ºF | ||
| Vertical SAG Resistance at 21°C (70°F) and 0.635mm (25mils) | No sag | ||
| Coverage for 10Kg kit | 115sf @20mils | 10.7m²@500micron | |
| Mix Ratio | 2:1 by weight | Base: Activator | |
| Color | Gray as standard. Blue and Red optional. Other colors contact the manufacturer | ||
| Shelf life (unopened containers) | 3 years at 55-95ºF (13-35ºC) | ||
Surface Preparation: Proper surface preparation is critical to the long-term performance of this product. The exact requirements for surface preparation vary with the severity of the application, expected service life, and the initial substrate conditions. All sharp edges and welds shall be ground smooth or to a 3 mm (120 mil) radius before abrasive blasting or mechanical preparation. The preparation must be mechanical minimum St2 or St3.
Mixing: Thoroughly mix Activator into Base with mixing stick or drill with low speed mixing blade scraping sides and bottom of container or mixing board. Mix by weight 2-parts Base to 1-part Activator. Mix thoroughly to produce an even colored and streak-free material. THINNING: Never thin.
Application: Brush: medium to stiff bristle of sufficient quality that bristles do not pull out and stick in coating (epoxy glued bristles are best). Trim or tape to <1” nap.
Roller: use good quality 1/8” nap.
FDA Compliance
This product complies with FDA regulations, for direct food contact specifically FDA 21 CFR 175.300 and FDA 21 CFR 175.105.
| 16°C (60°F) | 25°C (77°F) | 32°C (90°F) | |
|---|---|---|---|
| Tack Free | 6 hours | 4 hours | 3 hours |
| Light Load | 12 hours | 8 hours | 6 hours |
| Overcoat End | 16 hours | 10 hours | 8 hours |
| Full Load | 24 hours | 16 hours | 12 hours |
| Full Chemical | 48 hours | 24 hours | 18 hours |
Clean Up
Tools must be immediately cleaned after usage by using industrial alkaline detergent.
Safety
Before using any products, review the appropriate Safety Data Sheet (SDS) or Safety Sheet for your area. Follow standard confined space entry and work procedures, if appropriate.